Enterasys Matrix DFE-Gold Series

Configuring System Logging set logging default
10-6 System Logging Configuration
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThiscommandshowshowtodisplaytheSyslogserverdefaultvalues.Foranexplanationofthe
commandoutput,referbacktoTable 10‐1.
Matrix(rw)->show logging default.
Facility Severity Port
-----------------------------------------
Defaults: local4 warning(5) 514
set logging default
Usethiscommandtosetloggingdefaultvalues.
Syntax
set logging default {[facility facility] [severity severity] port port]}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
facilityfacility Specifiesthedefaultfacilityname.Validvaluesare:local0tolocal7.
severityseverity Specifiesthedefaultloggingseveritylevel.Validvaluesand
correspondinglevelsare:
1 - emergencies (system is unusable)
2 - alerts (immediate action required)
3 - critical conditions
4 - error conditions
5 - warning conditions
6 - notifications (significant conditions)
7 - informational messages
8 - debugging messages
portport SpecifiesthedefaultUDPporttheclientusestosendtotheserver.