Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Bridge Parameters clear spantree version
6-10 Spanning Tree Configuration
modewillcausethebridgetotransmitonly802.1DBPDUs,andwillpreventnon‐edgeportsfrom
rapidlytransitioningtoforwardingstate.
Example
ThisexampleshowshowtogloballychangetheSpanningTreeversionfromthe defaultofMSTP
toRSTP:
Matrix(rw)->set spantree version rstp
clear spantree version
UsethiscommandtoresettheSpanningTreeversiontoMSTPmode.
Syntax
clear spantree version
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoresettheSpanningTreeversion:
Matrix(rw)->clear spantree version
show spantree stpmode
UsethiscommandtodisplaytheSpanningTreeProtocol(STP)modesetting.
Syntax
show spantree stpmode
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.