Enterasys Matrix DFE-Gold Series

Configuring SMON show smon priority
11-8 Network Monitoring Configuration
Configuring SMON
Purpose
ToconfigureSMON(S witchedNetworkMonitoring)onthedevice.
Commands
show smon priority
UsethiscommandtodisplaySMONuserprioritystatistics.SMONgeneratesaggregatedstatistics
forIEEE802.1QVLANenvironments.
Syntax
show smon priority [port-string] [priority priority]
Parameters
Defaults
•Ifport‐stringisnotspecified,SMONstatisticsforallportswillbedisplayed.
•Ifpriorityisnotspecified,statisticsforallpriorityqueueswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaySMONpriority0statisticsfor1‐GigabitEthernetport14in
module3:
Matrix(rw)->show smon priority ge.3.14 0
Show Priority Statistics
For information about... Refer to page...
show smon priority 11-8
set smon priority 11-9
clear smon priority 11-9
show smon vlan 11-10
set smon vlan 11-11
clear smon vlan 11-11
port‐string (Optional)DisplaysSMONprioritystatisticsbeingcollectedbyspecific
port(s).Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage 4‐2.
prioritypriority (Optional)DisplaysSMONstatisticsbasedonencodeduserpriority,
Validvaluesare0‐7.