Enterasys Matrix DFE-Gold Series

router vrrp Configuring VRRP
Enterasys Matrix DFE-Gold Series Configuration Guide 21-61
Configuring VRRP
Purpose
ToenableandconfiguretheVirtualRouterRedundancyProtocol(VRRP).Thisprotocoleliminates
thesinglepointoffailureinherentinthestaticdefaultroutedenvironmentbytransferringthe
responsibilityfromoneroutertoanotheriftheoriginalroutergoesdown.VRRP‐enabledrouters
decidewhowillbecomemasterandwhowill
becomebackupintheeventthemasterfails.
Commands
router vrrp
UsethiscommandtoenableordisableVRRPconfigurationmode.
Syntax
router vrrp
no router vrrp
Parameters
None.
Defaults
None.
Mode
Routercommand,Globalconfiguration:Matrix>Router(config)#
For information about... Refer to page...
router vrrp 21-61
create 21-62
address 21-63
priority 21-64
master-icmp-reply 21-65
advertise-interval 21-66
critical-ip 21-66
preempt 21-67
preempt-delay 21-68
enable 21-69
ip vrrp authentication-key 21-70
ip vrrp message-digest-key 21-70
show ip vrrp 21-71