Enterasys Matrix DFE-Gold Series

Configuring the VLAN Egress List show vlan dynamic egress
7-20 802.1Q VLAN Configuration
show vlan dynamic egress
UsethiscommandtodisplaywhichVLANsarecurrentlyenabledforVLANdynamicegress.
Syntax
show vlan dynamicegress [vlan-list]
Parameters
Defaults
Ifvlan‐listisnotspecified,statusforallVLANswheredynamicegressisenabledwillbe
displayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaywhichVLANsareenabledfordynamicegress:
Matrix(rw)->show vlan dynamicegress
VLAN 1 is enabled
VLAN 101 is enabled
VLAN 102 is enabled
VLAN 105 is enabled
set vlan dynamicegress
Usethiscommandtosettheadministrativestatusof oneormoreVLANs’dynamicegress
capability.IfVLANdynamicegressisenabled,thedevicewilladdtheportreceivingatagged
frametotheVLANegresslistoftheportaccordingtotheframeVLANID.
Syntax
set vlan dynamicegress vlan-list {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
vlan‐list (Optional)DisplaysdynamicegressstatusforspecificVLAN(s).
vlan‐list SpecifiesthenumberoftheVLAN(s)wheredynamicegresswillbe
enabledordisabled.
enable|disable Enablesordisablesdynamicegress.