EasyManua.ls Logo

Enterasys Matrix DFE-Gold Series

Enterasys Matrix DFE-Gold Series
944 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
allow accessservers Configuring Load Sharing Network Address Translation (LSNAT)
Enterasys Matrix DFE-Gold Series Configuration Guide 19-27
Thisexampleshowshowtousestickysessionpersistence,inconjunctionwiththestickyserver
farmparameter.
Matrix>Router(config)#ip slb serverfarm lsnat
Matrix>Router(config-slb-sfarm)#sticky
Matrix>Router(config-slb-sfarm)#real 10.1.2.10 port 80
Matrix>Router(config-slb-real)#inservice
Matrix>Router(config-slb-real)#exit
Matrix>Router(config-slb-sfarm)#real 10.1.2.11 port 80
Matrix>Router(config-slb-real)#inservice
Matrix>Router(config-slb-real)#exit
Matrix>Router(config-slb-sfarm)#exit
Matrix>Router(config)#ip slb vserver virtual-lsnat
Matrix>Router(config-slb-vserver)#serverfarm lsnat
Matrix>Router(config-slb-vserver)#virtual 10.1.4.5 tcp 0
Matrix>Router(config-slb-vserver)#persistence level sticky
Matrix>Router(config-slb-vserver)#inservice
allow accessservers
Usethiscommandtoallowspecificclientstoaccesstheloadbalancingrealserversinaparticular
LSNATserverfarmwithoutaddresstranslation.
Syntax
allowaccessserversclient‐ip‐startclient‐ip‐end
noallowaccessserversclient‐ip‐startclient‐ip‐end
Parameters
Defaults
None.
Mode
Routercommand,SLBVirtualServerConfigurationmode:Matrix>Router(config‐slb‐vserver)#
Usage
Specifiedclientscansetupconnectionsdirectlytotherealservers’IPaddresses,aswellastothe
virtualserverIPaddress(VIP).Formoreinformationaboutusingthiscommand,see
“ConfiguringDirectAccesstoRealServers”onpage 19‐3.
The“no”formofthiscommandremovesnon‐LSNATaccess
permissionfromthespecifiedclients.
client‐ip‐start SpecifiesanIPaddressatthestartoftherangeofclientstobeallowed
access.
client‐ip‐end SpecifiesanIPaddressattheendoftherangeofclientstobeallowed
access.

Table of Contents

Related product manuals