Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Bridge Parameters set spantree spanguardtimeout
6-38 Spanning Tree Configuration
set spantree spanguardtimeout
Usethiscommandtosettheamountoftime(inseconds)anedgeportwillremainlockedbythe
spanguardfunction.
Syntax
set spantree spanguardtimeout timeout
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtosetthespanguardtimeoutto600seconds:
Matrix(rw)->set spantree spanguardtimeout 600
clear spantree spanguardtimeout
UsethiscommandtoresettheSpanningTreespanguardtimeouttothedefaultvalueof300
seconds.
Syntax
clear spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthespanguardtimeoutto300seconds:
Matrix(rw)->clear spantree spanguardtimeout
timeout Specifiesatimeoutvalueinseconds.Validvaluesare0(forever)to
65535.