Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Loop Protect Features show spantree lpcapablepartner
6-70 Spanning Tree Configuration
show spantree lpcapablepartner
UsethiscommandtotheLoopProtectcapabilityofalinkpartnerforoneormoreports.
Syntax
show spantree lpcapablepartner [port port-string]
Parameters
Defaults
Ifnoport‐stringisspecified,LoopProtectcapabilityforlinkpartnersisdisplayedforallports.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheLoopProtectpartnercapabilityforge.1.1:
Matrix(rw)->show spantree lpcapablepartner port ge.1.1
Link partner of port ge.1.1 is not LoopProtect-capable.
clear spantree lpcapablepartner
UsethiscommandtoresettheLoopProtectcapabilityofportlinkpartnerstothedefaultstateof
false.
Syntax
clear spantree lpcapablepartner port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoresettheLoopProtectpartnercapabilityforge.1.1:
Matrix(rw)->clear spantree lpcapablepartner ge.1.1
port‐string (Optional)Specifiesport(s)forwhichtodisplayLoopProtectcapability
foritslinkpartner.Foradetaileddescriptionofpossibleport‐string
values,referto“PortStringSyntaxUsedintheCLI”onpage 4‐2.
port‐string Specifiesport(s)forwhichtocleartheirlinkpartners’LoopProtect
capability(resettofalse).Foradetaileddescriptionofpossibleport‐
stringvalues,referto“PortStringSyntaxUsedintheCLI”onpage 4‐2.