Enterasys Matrix DFE-Gold Series

Configuring Link Traps and Link Flap Detection set linkflap interval
4-44 Port Configuration
set linkflap interval
Usethiscommandtosetthetimeinterval(inseconds)foraccumulatinglinkdowntransitions.
Syntax
set linkflap interval port-string interval_value
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Examples
Thisexampleshowshowtosetthelinkflapintervalonportfe.1.4to1000seconds:
Matrix(rw)->set linkflap interval fe.1.4 1000
set linkflap action
Usethiscommandtosetreactionstoalinkflapviolation.
Syntax
set linkflap action port-string {disableInterface | gensyslogentry | gentrap |
all}
Parameters
Defaults
None.
port‐string Specifiestheport(s)onwhichtosetthelinkflapinterval.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
interval_value Specifiesanintervalinseconds.Avalueof0willsettheintervalto
forever.
port‐string Specifiestheport(s)onwhichtosetthelinkflapaction.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
disableInterface|
gensyslogentry|
gentrap|all
Setsthereactionas:
•Disablingtheinterface
• GeneratingaSyslogentry
• Generating
anSNMPtrapmessage,or
•Alloftheabove.