Enterasys Matrix DFE-Gold Series

Configuring LACP set singleportlag
4-64 Port Configuration
Example
ThisexampleshowshowtodisplaythestatusofthesingleportLAGfunction:
Matrix(rw)->show lacp singleportlag
Single Port LAGs: enabled
set singleportlag
UsethiscommandtoenableordisabletheformationofsingleportLAGs.Whenenabled,this
maintainsLAGswhenonlyoneportisreceivingprotocoltransmissionsfromapartner.
Syntax
set lacp singleportlag {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoenablesingleportLAGs:
Matrix(rw)->set lacp singleportlag enable
clear singleportlag
UsethiscommandtoresetthesingleportLAGfunctionbacktothedefaultstateofdisabled.
Syntax
clear lacp singleportlag
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoresetthesingleportLAGfunctionbacktodisabled:
Matrix(rw)->clear lacp singleportlag
enable|disable Enablesordisablestheform ationofsingleportLAGs.