Enterasys Matrix DFE-Gold Series - Clear System Login

clear system login Setting User Accounts and Passwords
Enterasys Matrix DFE-Gold Series Configuration Guide 2-17
Defaults
allowed‐interval:00:00‐24:00(allhoursallowed)
allowed‐days:Sun,Mon,Tue,Wed,Thu,Fri,Sat(alldaysallowed)
local‐only:no.
Mode
Switchcommand,SuperUser.
Allowedintervalandalloweddaysmaybeconfiguredonanyuseraccountbutarenotenforced
onsuper‐useraccounts.
Example
Thisexampleshowshowtoenableanewuseraccountwiththeloginnamenetopswithsuper
useraccessprivileges:
Matrix(su)->set system login netops super-user enable
clear system login
Usethiscommandtoremovealocalloginuseraccountortoresetas pecifiedoptiontoitsdefault
value.
Syntax
clear system login username [allowed-interval] [allowed-days] [local-only]
Parameters
passwordpassword (Optional)Specifiestheencryptedpasswordforthisuseraccount.
NOTE: This option is intended only for use in configurations generated by the
show config command.
allowed‐interval
HH:MMHH:MM
(Optional)SpecifiesthestartandendhourHHandminuteMMtime
periodforwhichaccesswillbeallowedforthisuserbasedupon24
hourtime.
allowed‐days (Optional)Specifiesatleast1and
upto7daysoftheweekforwhich
accesswillbeallowedforthisuser.
local‐only (Optional)Specifiestheauthenticationscopeforthisuser.Validvalues:
yes,no.yesspecifiesthatauthenticationisonlybywayofthelocaluser
databaseevenwithRADIUSorTACACS+configured.nospecifies
that
authenticationisbywayofconfiguredmethods.
username Specifiestheloginnameoftheaccounttobeclearedifnooptional
parametersarespecified.Ifanoptionalparameter(s)isspecified,the
accountisnotclearedandthespecifiedparameter(s)isresettothe
defaultvalue.
Note: The default admin (su) account cannot be deleted.
allowed‐interval (Optional)Whenspecified,theconfiguredallowedintervalsetting is
resettothedefaultvalue.