show ip interface Configuring Routing Interface Settings
Enterasys Matrix DFE-Gold Series Configuration Guide 16-5
show ip interface
Usethiscommandtodisplayinformation,includingadministrativestatus,IPaddress,MTU
(MaximumTransmissionUnit)sizeandbandwidth,andACLconfigurations,forinterfaces
configuredforIP.
Syntax
show ip interface [vlan vlan-id | loopback loopback-id | lo loopback-id]
Parameters
Defaults
Ifinterfacetypeisnotspecified,statusinformationforallroutinginterfaceswillbedisplayed.
Mode
Routercommand,Anyroutermode.
Example
ThisexampleshowshowtodisplayconfigurationinformationforVLAN1:Matrix>Router#show
ipinterfacevlan1
Vlan 1 is Oper DOWN
Frame Type ARPA
MAC-Address 0001.f4da.2cba
Incoming Access List is not Set
Outgoing Access List is not Set
IP Helper Address is not Set
MTU is 1500 bytes
ARP Timeout is 14400 seconds
Proxy Arp is Enabled
Gratuitous arp learning is not set
ICMP Re-Directs are enabled
ICMP Unreachables are always sent
ICMP Mask Replies are always sent
Policy routing disabled
Table 16‐2providesanexplanationofthecommandoutput.
vlan vlan‐id|
loopbackloopback‐id
loloopback‐id
(Optional)DisplaysinformationforaspecificVLAN,loopback,orlocal
interface.ThisinterfacemustbeconfiguredforIProutingasdescribed
in“Pre‐RoutingConfigurationTasks”onpage 2‐100.
Table 16-2 show ip interface Output Details
Output... What it displays...
Vlan | Lpbk | Lo N Whether the interface is administratively and operationally up or down.
IP Address Interface’s IP address and mask. Set using the ip address command
as described in “ip address” on page 16-6.
Frame Type Encapsulation type used by this interface. Set using the arp command
as described in “arp” on page 16-14.