Enterasys Matrix DFE-Gold Series

DHCP Overview client-name
20-18 DHCP Configuration
Example
ThisexampleshowshowtoassignclientMACaddress00.01f4.0127within“clientclass1”:
Matrix>Router(config)#ip dhcp pool localpool
Matrix>Router(config-dhcp-pool)#client-identifier 0100.01f4.0127 client-class
clientclass1
client-name
UsethiscommandtoassignanametoaDHCPclient.
Syntax
client-name name [client-class name]
no client-name name
Parameters
Defaults
Ifclient‐classisnotspecified,nonewillbeassigned.
Mode
Routercommand,AnyDHCPconfigurationmode.
Usage
The“no”formofthiscommanddeletesaclientname.
Example
Thisexampleshowshowtoassign“soho1”asaclientnamein“clientclass1”:
Matrix>Router(config)#ip dhcp pool localpool
Matrix>Router(config-dhcp-pool)#client-name soho1 client-class clientclass1
hardware-address
UsethiscommandtospecifyparametersforanewDHCPclientaddress.
Syntax
hardware-address hardware-address [type]
no hardware-address hardware-address [type]
name SpecifiesanameforaDHCPclient.
Note: The client name should not include the domain name.
client‐classname (Optional)Specifiestheclasstowhichthisclientwillbeassigned.Must
beconfiguredusingtheclient‐classnameasdescribedin“client‐class”
onpage 20‐16.