Enterasys Matrix DFE-Gold Series

set flowlimit limit Configuring Flow Setup Throttling (FST)
Enterasys Matrix DFE-Gold Series Configuration Guide 24-27
Example
ThisexampleshowshowtoenableFSTonFastEthernetports1‐5inmodule2:
Matrix(rw)->set flowlimit fe.2.1-5 enable
set flowlimit limit
Usethiscommandtosetaflowlimitthatwilltriggeranactionforaportuserclassification.
Syntax
set flowlimit {limit1 | limit2 limit} [userport | serverport | aggregateduser |
interswitchlink | unspecified]
Parameters
Defaults
Ifclassificationporttypeisnotspecified,nonewillbeapplied.
Mode
Switchcommand,Read‐Write.
Usage
Onceconfigured,thislimitcanbe associatedwithanactionusingthesetflowlimitaction
commandasdescribedin“setflowlimitaction”onpage 24‐28.Thislimitcanbeassignedtooneor
moreportsusingthesetflowlimitclasscommandasdescribedin“setflowlimitport”on
page 24
‐31.
Example
Thisexampleshowshowtosettheflowlimit1to12flowsonportsclassifiedasuserports:
Matrix(rw)->set flowlimit limit1 12 userport
limit1|limit2 Specifiesthisconfigurationaslimit1or2.Twolimitsassignedtotwo
actions(describingwhatwilloccurwhenacertainflowlimitisreached)
canbedefinedperuserclassification.
limit Specifiesthenumberofflowsthatwilltriggertheassociatedaction
configuration.Validvaluesare0‐4294967295
.
userport|serverport
|aggregateduser|
interswitchlink|
unspecified
(Optional)Assignsthislimitconfigurationtotheuserclassificationport
type:
•userport
•serverport
•aggregationport
•inter‐switchlink
•unspecifiedport