Enterasys Matrix DFE-Gold Series

clear cdp Enterasys Discovery Protocol
Enterasys Matrix DFE-Gold Series Configuration Guide 3-7
Example
ThisexampleshowshowtosetCDPholdtimeto60seconds:
Matrix(rw)->set cdp hold-time 60
clear cdp
UsethiscommandtoresetCDPdiscoveryprotocolsettingstodefaults.
Syntax
clear cdp {[state] [port-state port-string] [interval] [hold-time] [auth-code]}
Parameters
Defaults
Atleastoneoptionalparametermustbeentered.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoresettheCDPstatetoauto‐enabled:
Matrix(rw)->clear cdp state
state (Optional)ResetstheglobalCDPstatetoauto‐enabled.
port‐stateport‐string (Optional)Resetstheportstateonspecificport(s)toauto‐enabled.
interval (Optional)Resetsthemessagefrequencyintervalto60seconds.
hold‐time (Optional)Resetstheholdtimevalueto180seconds.
auth‐code (Optional)Resetstheauthenticationcodeto16
bytesof00(00‐00‐00‐00‐
00‐00‐00‐00).