Enterasys Matrix DFE-Gold Series

set cdp auth Enterasys Discovery Protocol
Enterasys Matrix DFE-Gold Series Configuration Guide 3-5
Parameters
Defaults
Ifport‐stringisnotspecified,theCDPstatewillbegloballyset.
Mode
Switchcommand,Read‐Write.
Examples
ThisexampleshowshowtogloballyenableCDP:
Matrix(rw)->set cdp state enable
ThisexampleshowshowtoenabletheCDPforportfe.1.2:
Matrix(rw)->set cdp state enable fe.1.2
ThisexampleshowshowtodisabletheCDPforportfe.1.2:
Matrix(rw)->set cdp state disable fe.1.2
set cdp auth
UsethiscommandtosetaglobalCDPauthenticationcode.
Syntax
setcdpauthauth‐code
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Thisvaluedeterminesadevice’sCDPdomain.IftwoormoredeviceshavethesameCDP
authenticationcode,theywillbeenteredintoeachotherʹsCDPneighbortables.Iftheyhave
differentauthenticationcodes,theyareindifferentdomainsandwillnotbeenteredintoeach
other’sCDPneighbortables.
auto|disable|
enable
Auto‐enables,disablesorenables theCDPprotocolonthespecified
port(s).Inauto‐enablemode,whichisthedefaultmodeforallports,a
portautomaticallybecomesCDP‐enableduponreceivingitsfirstCDP
message.
port‐string (Optional)EnablesordisablesCDPonspecificport(s).For
adetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
auth‐code SpecifiesanauthenticationcodefortheCDPprotocol.Thiscanbeupto
16hexadecimalvaluesseparatedbycommas.