Enterasys Matrix DFE-Gold Series User Manual

interface Configuring Routing Interface Settings
Enterasys Matrix DFE-Gold Series Configuration Guide 16-3
Mode
Routercommand,Anyroutermode.
Example
Thisexampleshowshowtodisplayinformationforallinterfacesconfiguredontherouter.Inthis
case,oneloopbackinterfacehasbeenconfiguredforrouting.Foradetaileddescriptionofthis
output,refertoTable 16‐2Matrix>Router#showinterface:
Vlan 1 is Administratively DOWN
Vlan 1 is Operationally DOWN
Mac Address is: 0001.f4da.2cba
The name of this device is Vlan 1
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
Encapsulation ARPA, Loopback not set
ARP type: ARPA, ARP Timeout: 14400 seconds
lo is Administratively UP
lo is Operationally UP
Internet Address is 127.0.0.1, Subnet Mask is 255.255.255.0
The name of this device is lo
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
interface
UsethiscommandtoconfigureinterfacesforIProuting.
Syntax
interface {vlan vlan-id | loopback loopback-id}
Parameters
Defaults
None.
Mode
Routercommand,Globalconfigurationmode:Matrix>Router(config)#
Usage
Thiscommandenablesinterfaceconfigurationmodefromglobalconfigurationmode,and,ifthe
interfacehasnotpreviouslybeencreated,thiscommandcreatesanewroutinginterface.For
vlanvlan‐id|
loopbackloopback‐id
SpecifiesthenumberoftheVLANorloopbackint erfacetobe
configuredforrouting.Thisinterfacemustbe
configuredforIProuting
asdescribedin“Pre‐RoutingConfigurationTasks”onpage 2‐100.

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English