Enterasys Matrix DFE-Gold Series

show port jumbo Enabling / Disabling Jumbo Frame Support
Enterasys Matrix DFE-Gold Series Configuration Guide 4-27
Enabling / Disabling Jumbo Frame Support
Purpose
Toreview,enable,anddisablejumboframesupportononeormoreports.ThisallowsGigabit
Ethernetportstotransmitframesupto10KBinsize.
Commands
show port jumbo
Usethiscommandtodisplaythestatusofjumboframesupportandmaximumtransmissionunits
(MTU)ononeormoreports.
Syntax
show port jumbo [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,jumboframesupportstatusforallportswilldisplay.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythestatusofjumboframesupportforge.1.1:
Matrix(rw)->show port jumbo ge.1.1
Port Number Jumbo Oper Status Jumbo Admin Status Jumbo MTU
----------- ----------------- ------------------ ---------
ge.1.1 Disabled Disabled 10239
For information about... Refer to page...
show port jumbo 4-27
set port jumbo 4-28
clear port jumbo 4-28
port‐string (Optional)Displaysthestatusofjumboframesupportforspecific
port(s).Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage 4‐2.