Enterasys Matrix DFE-Gold Series

Resetting the Device show reset
2-94 Startup and General Configuration
Resetting the Device
Purpose
Toresetoneormoredevicemodules,tocleartheuser‐definedswitchandrouterconfiguration
parameters,ortoscheduleasystemresetinordertoloadanewbootimage.
Commands
Thecommandsusedtoresetthedeviceandcleartheconfigurationarelistedbelowanddescribed
intheassociatedsectionsasshown.
show reset
Usethiscommandtodisplayinformationaboutscheduleddeviceresets.
Syntax
show reset
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thiscommandshowshowtodisplayresetinformation
Matrix(rw)->show reset
Reset scheduled for Fri Jan 21 2000, 23:00:00 (in 3 days 12 hours 56 minutes 57
seconds).
Reset reason: Software upgrade
For information about... Refer to page...
show reset 2-94
reset 2-95
reset at 2-96
reset in 2-96
clear config 2-97