Link Layer Discovery Protocol and LLDP-MED show lldp port status
3-18 Discovery Protocols Configuration
show lldp port status
UsethiscommandtodisplaytheLLDPstatusofoneormoreports.
Syntax
show lldp port status [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,LLDPstatusinformationwillbedisplayedforallports.
Mode
Switchcommand,Read‐Only.
Usage
ThecommandliststheportsthatareenabledtosendandreceiveLLDPPDUs.Portsareenabledor
disabledwiththesetlldpportstatuscommand.
Example
ThisexampleshowshowtodisplayLLDPportstatusinform ationforallports.
Matrix(ro)->show lldp port status
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12; ge.5.1-12;
tg.6.1-2; fe.7.1-48
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12; ge.5.1-12;
tg.6.1-2; fe.7.1-48
show lldp port trap
UsethiscommandtodisplaytheportsthatareenabledtosendanLLDPnotificationwhena
remotesystemchangehasbeendetectedoranLLDP‐MEDnotificationwhenachangeinthe
topologyhasbeensensed.
Syntax
show lldp port trap [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,LLDPporttrapinformationwillbedisplayedforallports.
port-string (Optional)DisplaysLLDPstatusforoneorarangeofports.
port-string
(Optional)Displaystheportorrangeofportsthathavebeenenabledto
sendLLDPand/orLLDP‐MEDnotifications.