Enterasys Matrix DFE-Gold Series

Pausing, Clearing and Closing the CLI cls (clear screen)
2-92 Startup and General Configuration
Pausing, Clearing and Closing the CLI
Purpose
Toclearthe CLIscreenortocloseyourCLIsession.
Commands
ThecommandsusedtoclearandclosetheCLIsessionarelistedbelowanddescribedinthe
associatedsectionsasshown.
cls (clear screen)
UsethiscommandtoclearthescreenforthecurrentCLIsession.
Syntax
cls
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtocleartheCLIscreen:
Matrix(rw)->cls
exit | quit
UseeitherofthesecommandstoleaveaCLIsession.
Syntax
exit
quit
Parameters
None.
For information about... Refer to page...
cls (clear screen) 2-92
exit | quit 2-92