Enterasys Matrix DFE-Gold Series

no ip irdp multicast Configuring IRDP
Enterasys Matrix DFE-Gold Series Configuration Guide 21-59
Mode
Routercommand,Interfaceconfiguration:Matrix>Router(config‐if(Vlan1))#
Usage
The“no”formofthiscommandclearsanIPaddressfrombeingadvertised.
Example
ThisexampleshowshowtoadvertiseIPaddress183.255.0.162withapreferenceof1onVLAN1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip irdp address 183.255.0.162 1
no ip irdp multicast
UsethiscommandtoenabletheroutertosendIRDPadvertisementsusingbroadcastratherthan
multicasttransmissions.Bydefault,theroutersendsIRDPadvertisementsviamulticast.
Syntax
no ip irdp multicast
Parameters
None.
Defaults
None.
Mode
Routercommand,Interfaceconfiguration:Matrix>Router(config‐if(Vlan1))#
Example
ThisexampleshowshowtoenabletheroutertosendIRDPadvertisementsusingbroadcast:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#no ip irdp multicast
show ip irdp
UsethiscommandtodisplayIRDPinformation.
Syntax
show ip irdp [vlan vlan-id]
Parameters
vlanvlan‐id (Optional)DisplaysIRDPinformationforaspecificVLAN.ThisVLAN
mustbeconfiguredforIProutingasdescribedin“Pre‐Routing
ConfigurationTasks”onpage 2‐100.