Enterasys Matrix DFE-Gold Series

Managing Switch Network Addresses and Routes set newaddrtraps
12-14 Network Address and Route Management Configuration
Example
ThisexampleshowshowtodisplaythestatusofMACaddresstrapsonge.1.1through3:
Matrix(rw)->show newaddrtrap
New Address Traps Globally disabled
Port Enable State
--------- ------------
ge.1.1 disabled
ge.1.2 disabled
ge.1.3 disabled
set newaddrtraps
UsethiscommandtoenableordisableSNMPtrap messaging,globallyorononeormoreports,
whennewsourceMACaddressesaredetected.
Syntax
set newaddrtrap [port-string] {enable | disable}
Parameters
Defaults
Ifport‐stringisnotspecified,MACaddresstrapswillbegloballyenabledordisabled.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtogloballyenableMACaddresstraps:
Matrix(rw)->set newaddrtrap enable
show movedaddrtrap
UsethiscommandtodisplaythestatusofmovedMACaddresstrapsononeormoreports.
Syntax
show movedaddrtrap [port-string]
port‐string (Optional)Specifiestheport(s)onwhichtoenableordisableMAC
addresstraps.Foradetaileddescriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsedintheCLI”onpage 4‐2.
enable|disable EnablesordisablesSNMPtrapmessagingwhennewsourceMAC
addressesare
detected.