Enterasys Matrix DFE-Gold Series

clear spantree portenable Configuring Spanning Tree Port Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-51
clear spantree portenable
UsethiscommandtoresetthedefaultvalueforoneormoreSpanningTreeportstoenabled.
Syntax
clear spantree portenable port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoresetthedefaultSpanningTreeportstatusvaluetoenabledonfe.1.12:
Matrix(rw)->clear spantree portenable fe.1.12
show spantree portadmin
UsethiscommandtodisplaythestatusoftheSpanningTreealgorithmononeormoreports.
Syntax
show spantree portadmin [port port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,statuswillbedisplayedforallports.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplayportadminstatusforfe.1.7:
Matrix(rw)->show spantree portadmin port fe.1.7
Port fe.1.7 has portadmin set to enable
port‐string Specifiesport(s)toreset.Foradetaileddescription ofpossibleport‐
stringvalues,referto“PortStringSyntaxUsedintheCLI”onpage 4‐2.
portport‐string (Optional)Displaysstatusforspecificport(s).Foradetaileddescription
ofpossibleport‐stringvalues,referto“PortStringSyntaxUsedinthe
CLI”onpage 4‐2.