Enterasys Matrix DFE-Gold Series

Monitoring Network Events and Status show users
11-6 Network Monitoring Configuration
show users
UsethiscommandtodisplayinformationabouttheactiveconsoleportorTelnetsession(s)logged
intotheswitch.
Syntax
show users
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtousetheshowuserscommand.Inthisoutput,therearetwoTelnet
usersloggedinwithRead‐Writeaccesspriv ilegesfromIPaddresses134.141.192.119and
134.141.192.18:
Matrix(rw)->show users
Session User Location
-------- ----- --------------------------
* telnet rw 134.141.192.119
telnet rw 134.141.192.18
tell
Usethiscommandtosendamessagetooneorallusers.
Syntax
tell {dest | all} message
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
dest Specifiestheusertowhichthismessagewillbesent.Validsyntaxis
user@location.
all Sendsabroadcastmessagetoallusers.
message Textmessage.