Enterasys Matrix DFE-Gold Series

clear config Resetting the Device
Enterasys Matrix DFE-Gold Series Configuration Guide 2-97
Parameters
Defaults
Ifareasonisnotspecified,nonewillbeapplied.
Mode
Switchcommand,Read‐Write.
Example
Matrix(rw)‐>resetin5:20Thisexampleshowshowtoscheduleadeviceresetin5hoursand20
minutes:
Reset scheduled in 5 hours and 20 minutes
Proceed with scheduled reset? (y/n) [n]? y
Reset scheduled for 19:56:01, Wed March 15 2002 (in 5 hours 20 minutes
clear config
Usethiscommandtocleartheuser‐definedswitchandrouterconfigurationparametersforoneor
moremodules.
Syntax
clear config mod-num | all
Parameters
Defaults
None.
Mode
Read‐Write.
Usage
ExecutingclearconfigononeMatrixmoduleresetsthatmodulebacktoitsfactorydefaults.Ifthat
moduleisinachassiswithotheractivemodules,itwillinheritsystemsettingsfromthesystem.
Foralistoffactorydevicedefaultsettings,referto“FactoryDefaultSettings”onpage 2‐1.
ThiscommandwillnotaffecttheIPaddress.
Example
Thisexampleshowshowtoclearconfigurationparametersinallmodules:
Matrix(rw)->clear config all
hh:mm Specifiesthenumberofhoursandminutesintothefuturetoperforma
reset.
reason (Optional)Specifiesareasonforthereset
mod‐num|all Clearsconfigurationparametersinaspecificmoduleorinallmodules.