Enterasys Matrix DFE-Gold Series - Distribute-List

distribute-list Configuring RIP
Enterasys Matrix DFE-Gold Series Configuration Guide 21-17
distribute-list
Usethiscommandtofilternetworksreceivedandtosuppressnetworksfrombeingadvertisedin
RIPupdates.
Syntax
distribute-list access-list-number {in vlan vlan-id | out vlan vlan-id}
no distribute-list access-list-number {in vlan vlan-id | out vlan vlan-id}
Parameters
Defaults
None.
Mode
Routercommand,Routerconfiguration:Matrix>Router(config‐router)#
Usage
The“no”formofthiscommandremovesthefilter.
Example
Thisexampleshowshowtosuppressthenetwork192.5.34.0frombeingadvertisedinoutgoing
routingupdates:
Matrix>Router(config)#access-list 1 deny 192.5.34.0 0.0.0.255
Matrix>Router(config)#router rip
Matrix>Router(config-router)#distribute-list 1 out vlan
redistribute
Usethiscommandtoallowroutinginformationdiscoveredthroughnon‐RIPprotocolstobe
distributedinRIPupdatemessages.
Syntax
redistribute {connected | ospf process-id | static} [metric metric value]
[subnets]
no redistribute {connected | ospf process-id | static}
access‐list‐number SpecifiesthenumberoftheIPaccesslist.Thislistdefine swhich
networksaretobeadvertisedandwhicharetobesuppressedin
routingupdates.Fordetailsonhowtoconfigureaccesslists,referto
“ConfiguringAccessLists”onpage 24‐15.
invlanvlan‐id|out

vlanvlan‐id
Appliestheaccesslisttoincomingoroutgoingroutingupdatesonthe
specifiedVLAN.ThisVLANmustbeconfiguredforIProutingas
describedin“Pre‐RoutingConfigurationTasks”onpage 2‐100.