Enterasys Matrix DFE-Gold Series

show spantree backuproottrapendable Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-43
Example
ThisexampleshowshowtoresetthebackuprootfunctiontodisabledonSID2:
Matrix(rw)->clear spantree backuproot 2
show spantree backuproottrapendable
UsethiscommandtodisplaythestateoftheSpanningTreebackuproottrapfunction.
Syntax
show spantree backuproottrapenable
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythestatusofthebackuproottrapfunction:
Matrix(rw)->show spantree backuproottrapenable
Backup Root Trap is set to enable
set spantree backuproottrapenable
UsethiscommandtoenableordisabletheSpanningTreebackuproottrapfunction.
Syntax
set spantree backuproottrapenable {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
WhenSNMPtrapmessageingisconfigured,thissendsatrapmessagewhenthebackuproot
functionmakesaSpanningTreethenewrootofthenetwork.
enable|disable Enablesordisablesthebackuproottrapfunction.