Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Port Parameters clear spantree adminpoint
6-64 Spanning Tree Configuration
clear spantree adminpoint
Usethiscommandtoresettheadministrativepoint‐to‐pointstatusoftheLANsegmentattached
toaSpanningTreeporttoautomode.
Syntax
clear spantree adminpoint port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetpoint‐to‐pointstatustoautoonfe.2.3:
Matrix(rw)->clear spantree adminpoint fe.2.3
port‐string Specifiesport(s)onwhichtoresetpoint‐to‐pointprotocolstatus.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.