Enterasys Matrix DFE-Gold Series

reset Resetting the Device
Enterasys Matrix DFE-Gold Series Configuration Guide 2-95
reset
Usethiscommandtoresetthedevicewithoutlosinganyuser‐definedconfigurationsettings
Syntax
reset {[mod | system | nemcpu {mod.nemcpu}] [cancel]}
Parameters
Defaults
None.
Mode
Read‐Write.
Usage
AMatrixSeriesdevicecanalsoberesetwiththeRESETbuttonlocatedonitsfrontpanel.For
informationonhowtodothis,refertotheMatrixInstallationGuideshippedwithyourdevice.
Examples
Thisexampleshowshowtoresetthesystem.
Matrix(rw)->reset
This command will reset the system and may disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Resetting...
Thisexampleshowshowtocancelascheduledsystemreset:
Matrix(rw)->reset cancel
Reset cancelled.
ThisexampleshowshowtoresetaMatrixSecurityModuleinstalledontheDFEinslot4.
Matrix(rw)->reset nemcpu 4.1
This command will reset NEM CPU 4.1.
Do you want to continue (y/n) [n]? y
Resetting NEM CPU 4.1 ...
mod Specifiesamoduletobereset.
system Resetsthesystem.
nemcpu
mod.nemcpu ResetstheCPUonaMatrixSecurityModuleorotherprocessingNEM,
where
modspecifiestheDFEmoduleinwhichtheMatrixSecurity
ModuleorprocessingNEMisinstalledand
nemcpuspecifiesthe
locationoftheNEM.Currently,thisvaluecan onlybe1.
cancel Cancels aresetscheduledusingtheresetatcommandasdescribedin
“resetat”onpage 2‐96,ortheresetincommandasdescribedin“reset
in”onpage 2‐96.