Enterasys Matrix DFE-Gold Series

Configuring LACP clear lacp flowRegeneration
4-70 Port Configuration
Usage
Whenenabledandanewportjoinsalinkaggregationgroup(LAG),LACPwillredistributeall
existingflowsovertheLAG.Itwillalsoattempttoloadbalanceexistingflowstotakeadvantage
ofportsaddedtotheLAG.WhenflowregenerationisdisabledandanewportjoinsaLAG,
LACP
willonlydistributenewflowsovertheincreasednumberofportsintheLAGandwillleave
existingflowsintact.
Example
ThisexampleshowshowtoenableLACPflowregeneration:
Matrix(rw)->set lacp flowRegeneration enable
clear lacp flowRegeneration
UsethiscommandtoresetLACPflowregenerationtoitsdefaultstate(disabled).
Syntax
clear lacp flowRegeneration
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoresetLACPflowregenerationtodisabled:
Matrix(rw)->clear lacp flowRegeneration
show lacp outportAlgorithm
UsethiscommandtodisplaythecurrentLACPoutportalgorithm.
Syntax
show lacp outportAlgorithm
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.