Enterasys Matrix DFE-Gold Series

show pwa Configuring Port Web Authentication (PWA)
Enterasys Matrix DFE-Gold Series Configuration Guide 25-13
show pwa
Usethiscommandtodisplayportwebauthenticationinformationforoneormoreports.
Syntax
show pwa [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,PWAinformation willbedisplayedforallports.
Mode
Switchcommand,Read‐Only.
Examples
ThisexampleshowshowtodisplayPWAinformationforge.2.1:
Matrix(rw)->show pwa ge.2.1
PWA Status - enabled
PWA IP Address - 192.168.62.99
PWA Protocol - PAP
PWA Enhanced Mode - N/A
PWA Logo - enabled
PWA Guest Networking Status - disabled
PWA Guest Name - guest
PWA Redirect Time - N/A
Port Mode AuthStatus QuietPeriod MaxReq
-------- ---------------- -------------- ----------- ---------
ge.2.1 foreauthorized disconnected 60 16
Table 25‐1providesanexplanationofthecommandoutput.
set pwa maxrequests 25-24
set pwa portcontrol 25-24
show pwa session 25-25
For information about... Refer to page...
port‐string (Optional)DisplaysPWAinformationforspecificport(s).