Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Port Parameters show spantree portenable
6-50 Spanning Tree Configuration
show spantree portenable
UsethiscommandtodisplaytheportstatusononeormoreSpanningTreeports.
Syntax
show spantree portenable [port port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,statuswillbedisplayedforallports.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaystatusforportfe.1.12:
Matrix(rw)->show spantree portenable port fe.1.12
Port fe.1.12 has a Port Status of Enabled
set spantree portenable
UsethiscommandtosettheportstatusononeormoreSpanningTreeports.
Syntax
set spantree portenable port-string {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoenableSpanningTreeportfe.1.12:
Matrix(rw)->set spantree portenable fe.1.12 enable
portport‐string (Optional)Displaysstatusforspecificport(s).Foradetaileddescription
ofpossibleport‐stringvalues,referto“PortStringSyntaxUsedinthe
CLI”onpage 4‐2.
port‐string Specifiestheport(s)toenableordisable.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage 4‐2.
enable|disable EnablesordisablestheSpanningTreeport.