Enterasys Discovery Protocol set cdp state
3-4 Discovery Protocols Configuration
CDP Authentication Code : 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0
0x0 0x0
CDP Transmit Frequency : 60
Port Status
-----------------
fe.1.1 auto-enable
fe.1.2 auto-enable
fe.1.3 auto-enable
fe.1.4 auto-enable
fe.1.5 auto-enable
fe.1.6 auto-enable
fe.1.7 auto-enable
fe.1.8 auto-enable
fe.1.9 auto-enable
Table 3‐1providesanexplana tion ofthecommandoutput.
set cdp state
UsethiscommandtoenableordisabletheCDPdiscoveryprotocolononeormoreports.
Syntax
set cdp state {auto | disable | enable} [port-string]
Table 3-1 show cdp Output Details
Output... What it displays...
CDP Global Status Whether CDP is globally auto-enabled, enabled or disabled. The
default state of auto-enabled can be reset with the set cdp state
command. For details, refer to “set cdp state” on page 3-4.
CDP Versions Supported CDP version number(s) supported by the device.
CDP Hold Time Minimum time interval (in seconds) at which CDP configuration
messages can be set. The default of 180 seconds can be reset with
the set cdp hold-time command. For details, refer to “set cdp hold-
time” on page 3-6.
CDP Authentication Code Authentication code for CDP discovery protocol. The default of 00-00-
00-00-00-00-00-00 can be reset using the set cdp auth command. For
details, refer to “set cdp auth” on page 3-5.
CDP Transmit Frequency Frequency (in seconds) at which CDP messages can be transmitted.
The default of 60 seconds can be reset with the set cdp interval
command. For details, refer to “set cdp interval” on page 3-6.
Port Port designation. For a detailed description of possible port-string
values, refer to “Port String Syntax Used in the CLI” on page 4-2.
Status Whether CDP is enabled, disabled or auto-enabled on the port.
To Next Page
Loading...
Need help?
General