Enterasys Matrix DFE-Gold Series

set ciscodp timer Cisco Discovery Protocol
Enterasys Matrix DFE-Gold Series Configuration Guide 3-11
set ciscodp timer
UsethiscommandtosetthenumberofsecondsbetweenCiscoDiscoveryProtocolPDU
transmissions.
Syntax
set ciscodp timer time
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosettheCiscoDiscoveryProtocoltimerto120seconds:
Matrix>set ciscodp timer 120
set ciscodp holdtime
Usethiscommandtosetthetimetolive(TTL)forCiscoDiscoveryProtocolPDUs.Thisisthe
amountoftime(inseconds) neighboringdeviceswillholdPDUtransmissionsfromthesending
device.
Syntax
set ciscodp holdtime time
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosettheCiscoDiscoveryProtocolholdtimeto180seconds:
Matrix>set ciscodp holdtime 180
time SpecifiesthenumberofsecondsbetweenCiscoDPPDUtransmissions.
Validvaluesare5‐254.
time SpecifiesthetimetoliveforCiscoDPPDUs.Validvaluesare10‐255.