EasyManua.ls Logo

Enterasys Matrix DFE-Gold Series

Enterasys Matrix DFE-Gold Series
944 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring OSPF passive-interface
21-36 Routing Protocol Configuration
Defaults
None.
Mode
Routercommand,Routerconfiguration:Matrix>Router(configrouter)#
Usage
The“no”formofthiscommandremovesthevirtuallink.
Example
ThisexampleshowshowtoconfigureavirtuallinkbetweenOSPFarea0.0.0.2andABRnetwork
134.141.7.2:
Matrix>Router(config)#router ospf 1
Matrix>Router(config-router)#area 0.0.0.2 virtual-link 134.141.7.2
passive-interface
UsethiscommandtoenablepassiveOSPFonaninterface.
Syntax
passive-interface vlan vlan-id
no passive-ospf vlan vlan-id
Parameters
Defaults
None.
authentication‐key
key
Specifiesapasswordtobeusedbyneighborrouters.Validvaluesare
alphanumericstringsofupto8bytes.Neighborroutersonanetwork
musthavethesamepassword.
deadintervalseconds Specifiesthenumberofsecondsthatthehellopacketsofarouterare
notcommunicatedtoneighbor
routersbeforetheneighborrouters
determinethattheroutersendingthehellopacketisoutofservice.This
valuemustbethesameforallnodesattachedtoacertainsubnet,andit
isavaluerangingfrom1to8192.
hellointervalseconds Specifiesthenumberofsecondsbetweenhello
packetsonaninterface.
Thisvaluemustbethesameforallnodesattachedtoanetworkanditis
avaluerangingfrom1to8192.
retransmit
intervalseconds
Specifiesthenumberofsecondsbetweensuccessiveretransmissionsof
thesameLSAs.Validvaluesaregreaterthantheexpectedamountof
timerequiredfortheupdatepackettoreachandreturnfromthe
interface,andrangefrom1to8192.
transmitdelayseconds Specifiestheestimatednumberofsecondsforalinkstateupdatepacket
ontheinterfacetobetransmitted.Validvaluesrangefrom1to8192.
vlanid SpecifiestheinterfaceonwhichtoenablepassiveOSPFmode.

Table of Contents

Related product manuals