Enterasys Matrix DFE-Gold Series

show timezone Configuring Simple Network Time Protocol (SNTP)
Enterasys Matrix DFE-Gold Series Configuration Guide 13-9
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtocleartheSNTPpolltimeout:
Matrix(rw)->clear sntp poll-timeout
show timezone
UsethiscommandtodisplaySNTPtimezonesettings.
Syntax
show timezone
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaySNTPtimezonesettings:
Matrix(rw)->show timezone
Admin Config timezone: '', offset from UTC is 5 hours and 0 minutes
Oper Config timezone: '', offset from UTC is 5 hours and 0 minutes
set timezone
UsethiscommandtosettheSNTPtimezonenameandthehoursandminutesitisoffsetfrom
CoordinatedUniversalTime(UTC).
Syntax
set timezone name [hours] [minutes]
Parameters
name Specifiesthetimezonename.
hours (Optional)Specifiesthenumberofhoursthistimezonewillbeoffset
fromUTC.Validvaluesareminus12(‐12)to12.
minutes (Optional)Specifiesthenumberofminutesthistimezonewillbeoffset
fromUTC.Validvaluesare0to59.