Index-1
Index
Numerics
802.1D 6-1
802.1Q 7-1
802.1w 6-1
802.1x 25-54, 25-65
A
Access Groups 24-20
Access Lists 24-16 to 24-17
Addresses
IP, adding to switch routing
table 12-8
MAC, adding entries to routing
table 16-6
MAC, setting for IP routing 16-17
setting the router ID address 21-24
Advertised Ability 4-30
Alias
node 14-1, 15-1
physical 2-54
Area Border Routers (ABRs) 21-31
ARP
entries, adding in routing
mode 16-14
entries, adding in switch mode 12-3
proxy, enabling 16-16
timeout 16-17
Authentication
MAC 25-26
MD5 21-30
Multi 27-1
OSPF
area 21-32
MD5 21-30
simple password 21-29
Port web 25-11
RADIUS server 25-54, 25-57, 25-65
SSH 24-12
VRRP 21-70
Auto-negotiation 4-30
B
Baud Rate 4-5
Broadcast
settings for IP routing 16-19
suppression, enabling on ports 4-49
C
CIDR 21-13
Cisco Discovery Protocol
configuring 3-8
Class of Service 8-8, 8-14, 8-21
Classification Policies 8-1
Classification Rules 8-7
Clearing NVRAM 2-97
CLI
closing 2-92
scrolling screens 2-10
starting 2-7
Command History Buffer 11-1, 11-2
Command Line Interface. See also CLI
Configuration
clearing switch parameters 2-97
modes for router operation 2-103
Configuration Files
copying 2-86
deleting 2-87
displaying 2-85
executing 2-86
saving or writing to output
devices 16-9
show running config 2-87
Console Port Settings 4-3
Contexts (SNMP) 5-3
Convergence End Points (CEP) phone
detection 25-39
Copying Configuration or Image
Files 2-86
Cost
area default 21-34
OSPF 21-24, 21-34
Spanning Tree port 6-60
D
Debugging
OSPF 21-50
Defaults
CLI behavior, described 2-6
factory installed 2-1
DHCP Server 20-1
Discovery Protocols
about 3-1
Cisco Discovery Protocol 3-8
Enterasys Discovery Protocol 3-3
LLDP and LLDP-MED 3-15
DoS prevention 24-22
DVMRP 21-52
Dynamic Egress 7-20
E
Enterasys Discovery Protocol
configuring 3-3
F
Flow Control 4-37
Flow Setup Throttling (FST) 24-25,
25-60
G
Getting Help 1-2
GVRP
enabling and disabling 7-26
purpose of 7-22
timer 7-27
H
H.323 detection 25-39
Hardware
show system 2-35, 2-48
Hello Packets 21-28
Help
context sensitive 2-9
keyword lookups 2-9
I
ICMP 11-4, 16-27
IGMP 9-1
enabling and disabling 9-2
Image File
copying 2-86
downloading 2-72
Ingress Filtering 7-9, 7-14
Interface Configuration Mode 16-3
Interface(s)
configuring OSPF parameters 21-21
configuring settings for IP 16-1
RIP passive 21-15
RIP receive 21-16
RIP send 21-7
IP
access lists 24-16 to 24-17
address, setting for a routing
interface 16-6
addresses, adding to the switch
routing table 12-8
routes, adding in router mode 16-26
routes, managing in switch
mode 12-1
IRDP 21-55
J
Jumbo Frame Support 4-27
K
Keyword Lookups 2-9
L
License key
advanced routing 2-58, 21-1
Line Editing Commands 2-11
Link Layer Discovery Protocol (LLDP)
configuring 3-15
Link State Advertisements
displaying 21-43
retransmit interval 21-26
transmit delay 21-27
LLDP
configuring 3-15
LLDP-MED
configuring 3-15
Lockout
set system 2-23
Logging 10-1
To Next Page
Loading...
