Enterasys Matrix DFE-Gold Series

set spantree protomigration Configuring Spanning Tree Port Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-53
set spantree protomigration
UsethiscommandtoresettheprotocolstatemigrationmachineforoneormoreSpanningTree
ports.WhenoperatinginRSTPmode,thisforcesaporttotransmitMSTPBPDUs.
Syntax
set spantree protomigration port-string true
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresettheprotocolstatemigrationmachineonfe.1.12:
Matrix(rw)->set spantree protomigration fe.1.12 true
show spantree portstate
Usethiscommandtodisplaythestate(blocking,forwarding,etc.)foraportononeormore
SpanningTrees.
Syntax
show spantree portstate [port port-string] [sid sid]
Parameters
Defaults
•Ifport‐stringisnotspecified,currentstatewillbedisplayedforallSpanningTreeports.
•Ifsidisnotspecified,currentportstatewillbedisplayedforSpanningTree0.
Mode
Switchcommand,Read‐Only.
port‐string Specifiestheport(s)forwhichprotocolmigrationmodewillbeenabled.
Foradetaileddescriptionofpossibleport‐stringvalues,referto“Port
StringSyntaxUsedintheCLI”onpage 4‐2.
true Enablesprotocolmigrationmode.
portport‐string (Optional)DisplaystheSpanningTreestate forspecificSpanningTree
port(s).Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage 4‐2.
sidsid (Optional)DisplaysthestateforaspecificSpanningTreeidentifier.
Validvaluesare0‐
4094.Ifnotspecified,SID0isassumed.