EasyManua.ls Logo

Enterasys Matrix DFE-Gold Series

Enterasys Matrix DFE-Gold Series
944 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Enterasys Matrix DFE-Gold Series Configuration Guide 5-1
5
SNMP Configuration
ThischapterdescribestheSimpleNetworkManagementProtocol(SNMP)setofcommandsand
howtousethem.
SNMP Configuration Summary
SNMPisanapplicationlayerprotocolthatfacilitatesthe exchangeofmanagementinformation
betweennetworkdevices.SNMPenablesnetworkadministratorstomanagenetwork
performance,findandsolvenetworkproblems,andplanfornetworkgrowth.
MatrixSeriesdevicessupportthreeversionsofSNMP:
•Version1(SNMPv1)Thisistheinitialimplementation
ofSNMP.RefertoRFC1157forafull
descriptionoffunctionality.
•Version2(SNMPv2c)ThesecondreleaseofSNMP,describedinRFC1907,hasadditions
andenhancementstodatatypes, countersize,andprotocoloperations.
•Version3(SNMPv3)ThisisthemostrecentversionofSNMP,andincludes
significant
enhancementstoadministrationandsecurity.SNMPv3isfullydescribedinRFC2571,RFC
2572,RFC2573,RFC2574,andRFC2575.
Note: Commands for configuring SNMP on the Matrix Series device are independent during the
SNMP setup process. For instance, target parameters can be specified when setting up optional
notification filters — even though these parameters have not yet been created with the set snmp
targetparams command.
For information about... Refer to page...
SNMP Configuration Summary 5-1
Reviewing SNMP Statistics 5-5
Configuring SNMP Users, Groups and Communities 5-10
Configuring SNMP Access Rights 5-18
Configuring SNMP MIB Views 5-22
Configuring SNMP Target Parameters 5-26
Configuring SNMP Target Addresses 5-29
Configuring SNMP Notification Parameters 5-33
Configuring SNMP Walk Behavior 5-41

Table of Contents

Related product manuals