Startup and General Configuration Summary
2-2 Startup and General Configuration
Table 2-1 Default Device Settings for Basic Switch Operation
Device Feature Default Setting
CDP discovery protocol Auto enabled on all ports.
CDP authentication code Set to 00-00-00-00-00-00-00-00
CDP hold time Set to 180 seconds.
CDP interval Transmit frequency of CDP messages set to 60 seconds.
Cisco Discovery Protocol Globally auto-enabled, enabled on ports.
Community name Public.
Convergence End Points
phone detection
Disabled globally and on all ports
EAPOL Disabled.
EAPOL authentication
mode
When enabled, set to auto for all ports.
GARP timer Join timer set to 20 centiseconds; leave timer set to 60 centiseconds; leaveall
timer set to 1000 centiseconds.
GVRP Globally enabled.
IGMP Disabled. When enabled, query interval is set to 125seconds and response
time is set to 100 tenths of a second.
IP mask and gateway Subnet mask set to 255.0.0.0; default gateway set to 0.0.0.0
IP routes No static routes configured.
Jumbo frame support Disabled on all ports.
Link aggregation admin
key
Set to 32768 for all ports.
Link aggregation flow
regeneration
Disabled.
Link aggregation system
priority
Set to 32768 for all ports.
Link aggregation outport
algorithm
Set to DIP-SIP.
Link Layer Discovery
Protocol (LLDP)
Both transmitting and receiving LLDPDUs are enabled.
LLDP transmit interval 30 seconds
LLDP hold multiplier 4
LLDP trap interval 5 seconds
LLDP-MED fast repeat 3 fast start LLDPDUs
LLDP traps Disabled
LLDP-MED traps Disabled
Lockout Set to disable Read-Write and Read-Only users, and to lockout the default
admin (Super User) account for 15 minutes, after 3 failed login attempts,
Logging Syslog port set to UDP port number 514. Logging severity level set to 6
(significant conditions) for all applications.
To Next Page
Loading...
Need help?
General