Configuring Spanning Tree Port Parameters show spantree adminpoint
6-62 Spanning Tree Configuration
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaytheedgeportstatusforfe.2.7:
Matrix(rw)->show spantree operedge port fe.2.7
Port fe.2.7 has a Port Oper Edge of Edge-Port
show spantree adminpoint
Usethiscommandtodisplaytheadministrativepoint‐to‐pointstatusoftheLANsegment
attachedtoaSpanningTreeport.
Syntax
show spantree adminpoint [port port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,statuswillbedisplayedforallSpanningTreeport(s).
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythepoint‐to‐pointstatus oftheLANsegmentattachedto
fe.2.7:
Matrix(rw)->show spantree adminpoint port fe.2.7
Port fe.2.7 has a Port Admin Point to Point of Auto
show spantree operpoint
Usethiscommandtodisplaytheoperatingpoint‐to‐pointstatusoftheLANsegmentattachedtoa
port.
Syntax
show spantree operpoint [port port-string]
Parameters
portport‐string (Optional)Displayspoint‐to‐pointstatusforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.
portport‐string (Optional)Displayspoint‐to‐pointoperatingstatusforspecificport(s).
Foradetaileddescriptionofpossibleport‐stringvalues,referto“Port
StringSyntaxUsedintheCLI”onpage 4‐2.
To Next Page
Loading...
Need help?
General