Enterasys Matrix DFE-Gold Series

show port priority-queue Configuring Priority to Transmit Queue Mapping
Enterasys Matrix DFE-Gold Series Configuration Guide 22-5
Configuring Priority to Transmit Queue Mapping
Purpose
Toperformthefollowing:
•Viewthecurrentprioritytotransmitqueuemappingofeachport,whichincludesboth
physicalandvirtualports.
• Configureeachporttoeithertransmitframesaccordingtotheportprioritytransmitqueues
(setusingthesetportprioritycommanddescribedbackin“setportpriority”onpage 22
‐3),
oraccordingtoaprioritybasedonapercentageofporttransmissioncapacity(setusingthe
setpriorityqueuecommanddescribedin“setportpriority‐queue”onpage 22‐6).
•Clearcurrentportpriorityqueuesettingsforoneormoreports.
Commands
show port priority-queue
Usethiscommandtodisplaytheportprioritylevels(0 through7,with0asthelowestlevel)
associatedwiththecurrenttransmitqueue(0‐15dependingonporttype,with0beingthelowest
priority)foreachpriorityoftheselectedport.
Syntax
show port priority-queue [priority]
Parameters
Defaults
Ifpriorityisnotspecified,allpriorityqueueinformationwillbedisplayed.
Mode
Switchcommand,Read‐Only.
Usage
Aframewithacertainportpriorityistransmittedaccordingtothesettingsenteredusingtheset
priorityqueuecommanddescribedin“setportpriority‐queue”onpage 22‐6.
For information about... Refer to page...
show port priority-queue 22-5
set port priority-queue 22-6
clear port priority-queue 22-7
priority (Optional)Displaysqueuelevelsforaspecificpriorityvalue.