Enterasys Matrix DFE-Gold Series

show port mac Managing Switch Network Addresses and Routes
Enterasys Matrix DFE-Gold Series Configuration Guide 12-9
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoclearthedefaultgateway:
Matrix(rw)->clear ip route default
show port mac
UsethiscommandtodisplaytheMACaddress(es)foroneormoreports.
Syntax
show port mac [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,MACaddressesforallportswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Usage
TheseareportMACaddressesprogrammedintothedeviceduringmanufacturing.Toshowthe
MACaddresseslearnedonaportthroughtheswitchingprocess,usetheshowmaccommandas
describedin“showmac”onpage 12‐10.
Example
ThisexampleshowshowtodisplaytheMACaddressfor1‐GigabitEthernetport4inmodule2:
Matrix(rw)->show port mac fe.2.4
Port MAC Address
------------ ----------------------
fe.2.4 00-01-F4-DA-32-FE
port‐string (Optional)DisplaysMACaddressesforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.