To Next Page

To Previous Page

Configuring SNMP Target Addresses set snmp targetaddr

5-30 SNMP Configuration

Retry count = 4

Parameters = v2cParams

Storage type = nonVolatile

Row status = active

Table 5‐10showsadetailedexplanationofthecommandoutput.

set snmp targetaddr

UsethiscommandtoconfigureanSNMPtargetaddress.

Syntax

set snmp targetaddr targetaddr ipaddr param param [udpport udpport] [mask mask]

[timeout timeout] [retries retries] [taglist taglist] [volatile | nonvolatile]

Parameters

Table 5-10 show snmp targetaddr Output Details

Output... What it displays...

Target Address Name Unique identifier in the snmpTargetAddressTable.

Tag List Tags a location to the target address as a place to send notifications.

IP Address Target IP address.

UDP Port# Number of the UDP port of the target host to use.

Target Mask Target IP address mask.

Timeout Timeout setting for the target address.

Retry count Retry setting for the target address.

Parameters Entry in the snmpTargetParamsTable.

Storage type Whether entry is stored in volatile, nonvolatile, or read-only memory.

Row status Status of this entry: active, notInService, or notReady.

targetaddr SpecifiesauniqueidentifiertoindexthesnmpTargetAddrTable.

Maximumlengthis32bytes.

ipaddr SpecifiestheIPaddressofthetarget.

paramparam SpecifiesanentryintheSNMPtargetparameterstable,whichisused

whengeneratingamessagetothetarget.Maximumlengthis32bytes.

udpportudpport (Optional)SpecifieswhichUDP

portofthetargethosttouse.

maskmask (Optional)SpecifiestheIPmaskofthetarget.

timeouttimeout (Optional)Specifiesthemaximumroundtriptimeallowedto

communicatetothistargetaddress.Thisvalueisin.01secondsandthe

defaultis1500(15seconds.)

retriesretries (Optional)Specifiesthe numberof

messageretriesallowedifaresponse

isnotreceived.Defaultis3.

Enterasys Matrix DFE-Gold Series User Manual

Questions and Answers: