Enterasys Matrix DFE-Gold Series

show ip nat translations Configuring Network Address Translation (NAT)
Enterasys Matrix DFE-Gold Series Configuration Guide 18-9
Defaults
Ifsecondsisnotspecified,seetheparametertableaboveforthedefaultvalue.
Mode
Routercommand,Globalconfiguration:Matrix‐>Router(config)#
Usage
Thenoversionofthecommandresetsthetimeoutstothedefaultvalue.
Example
ThisexamplesetsthetimeoutvalueappliedtoUDPflowsto400:
Matrix->Router(config)#ip nat translation udp-timeout 400
show ip nat translations
UsethiscommandtodisplayactiveNATtranslations.
Syntax
show ip nat translations [verbose]
Parameters
None.
Defaults
Ifverboseisnotspecified,standardoutputisdisplayed.
Mode
Routercommand,Globalconfiguration:Matrix‐>Router(config)#
Examples
ThisexampleshowsadynamicNAPTtranslationsdisplayforthisrouter:
Matrix->Router(config)#show ip nat translations
Proto Outside-global Inside-local Type No. of Flows
------------------------------------------------------------------------------
tcp 81.1.1.1:1024 172.111.1.4:50020 DynOver 14
tcp 81.1.1.1:1025 172.111.1.4:50021 DynOver 2
tcp 81.1.1.1:1026 172.111.1.4:50022 DynOver 10
tcp 81.1.1.1:1027 172.111.1.4:50023 DynOver 2
tcp 81.1.1.1:1029 172.111.1.4:50024 DynOver 3
dns‐timeout SpecifiesthetimeoutvalueappliedtotheDNStranslations.Default:
240seconds.
ftp‐timeout SpecifiesthetimeoutvalueappliedtotheFTPtranslations.Default:240
seconds.
seconds Specifiesthetimeoutvalueinseconds.