Setting Basic Device Properties clear mgmt-auth-notify
2-30 Startup and General Configuration
Setting Basic Device Properties
Purpose
Toî ±displayî ±andî ±setî ±theî ±systemî ±IPî ±addressî ±andî ±otherî ±basicî ±systemî ±(device)î ±properties,î ±includingî ±
time,î ±contactî ±nameî ±andî ±alias,î ±physicalî ±assetî ±IDsî ±forî ±modules,î ±terminalî ±output,î ±timeout,î ±andî ±
versionî ±information.
Commands
For information about... Refer to page...
show ip address 2-31
set ip address 2-31
clear ip address 2-32
show ip gratuitous-arp 2-32
set ip gratuitous-arp 2-33
clear ip gratuitous-arp 2-33
show system 2-34
show system hardware 2-35
show system utilization 2-37
set system utilization threshold 2-39
clear system utilization 2-40
show time 2-40
set time 2-41
show summertime 2-41
set summertime 2-42
set summertime date 2-42
set summertime recurring 2-43
clear summertime 2-44
set prompt 2-44
set cli completion 2-45
loop 2-45
show banner 2-46
set banner 2-47
clear banner 2-48
show version 2-48
set system name 2-50
set system location 2-50
To Next Page
Loading...
Need help?
General