Enterasys Matrix DFE-Gold Series - Set Lacp Aadminkey; Clear Lacp

set lacp aadminkey Configuring LACP
Enterasys Matrix DFE-Gold Series Configuration Guide 4-61
Usage
OnlyoneLACPsystemprioritycanbesetonaMatrixSeriesdevice,usingeitherthiscommand,or
thesetportlacpcommand(“setportlacp”onpage 4‐66).
LACPusesthisvaluetodetermineaggregationprecedence.Iftherearetwopartnerdevices
competingforthesameaggregator,LACPcompares
theLAGIDsforeachgroupingofports.The
LAGwiththelowerLAGIDisgivenprecedenceandwillbeallowedtousetheaggregator.
Example
ThisexampleshowshowtosettheLACPsystempriorityto1000:
Matrix(rw)->set lacp asyspri 1000
set lacp aadminkey
Usethiscommandtosettheadministrativelyassignedkeyforoneormoreaggregatorports.
LACPwillusethisvaluetoformanoperkey.Onlyunderlyingphysicalportswithoperkeys
matchingthoseoftheiraggregatorswillbeallowedtoaggregate.
Syntax
set lacp aadminkey port-string value
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosettheLACPadminkeyto2000forLAGport4:
Matrix(rw)->set lacp aadminkey lag.0.484 2000
clear lacp
UsethiscommandtoclearLACPsystempriorityoradminkeysettings.
Syntax
clear lacp {[asyspri] [aadminkey port-string]}
Parameters
port‐string SpecifiestheLAGport(s)onwhichtoassignanadminkey.
value Specifiesanadminkeyvaluetoset.Validvaluesare0to65535.
asyspri Clearssystempriority.
aadminkeyport‐string Clearsadminkeysforoneormoreports.