Enterasys Matrix DFE-Gold Series

show inlinepower Configuring Power over Ethernet (PoE)
Enterasys Matrix DFE-Gold Series Configuration Guide 2-61
Configuring Power over Ethernet (PoE)
Purpose
ToreviewandsetPoEparameters,includingthepoweravailabletothechassis,theusage
thresholdforeachmodule,whetherornotSNMPtrapmessageswillbesentwhenpowerstatus
changes,andper‐portPoEsettings.
Commands
show inlinepower
UsethiscommandtodisplaydevicePoEproperties.
Syntax
show inlinepower
Important Notice
This section applies only to PoE-equipped Matrix devices. Consult the Installation Guide shipped with your
product to determine if it is PoE-equipped.
For information about... Refer to page...
show inlinepower 2-61
set inlinepower mode 2-62
clear inlinepower mode 2-63
set inlinepower available 2-63
clear inlinepower available 2-64
set inlinepower powertrap 2-65
clear inlinepower powertrap 2-65
set inlinepower assigned 2-66
clear inlinepower assigned 2-66
set inlinepower threshold 2-67
clear inlinepower threshold 2-67
set inlinepower management 2-68
clear inlinepower management 2-68
set inlinepower psetrap 2-69
clear inlinepower psetrap 2-69
show port inlinepower 2-70
set port inlinepower 2-70
clear port inlinepower 2-71