Enterasys Matrix DFE-Gold Series - Set Rad; Show Rad

Managing Switch Network Addresses and Routes show rad
12-4 Network Address and Route Management Configuration
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtodeleteentry10.1.10.10fromtheARPtable:
Matrix(rw)->clear arp 10.1.10.10
show rad
UsethiscommandtodisplaythestatusoftheRAD(RuntimeAddressDiscovery)protocolonthe
switch.
Syntax
show rad
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplayRADstatus:
Matrix(rw)->show rad
RAD is currently enabled.
set rad
UsethiscommandtoenableordisableRAD(RuntimeAddressDiscovery)protocol.
Syntax
setrad{enable|disable}
Parameters
ip|all SpecifiestheIPaddressintheARPtabletobecleared,orclearsallARP
entries.
enable|disable EnablesordisablesRAD.